A miter saw is a saw used to make accurate crosscuts and miters in a workplace. Table saws, on the other hand, is used for woodworking and consists of a circular round blade driven by an electric motor. The blade protrudes through the surface of a table, which provides support for the material which is usually wood, being cut. The best compound miter saw on the other hands, can make a cross cut on any board of any length. It can also make a rip cut on a very short board that doesn’t exceed the cut length of the miter saw.
Generally, for cross cuts, if the wood is bulky and hard to move because of its weight, then the preference would be a mitre saw.
The Steps Following A Crown Moulding Include:
- To make a scarf joint in the middle of a long run, start by placing the crown moulding upside down on mitre saw table; hold the moulding at the same angle as it will be installed.
- Set blade at 45 degrees and make cut in two lengths of moulding to create a scarf joint.
- To form an outside corner joint, set the saw blade at 45 degrees to the left; cut the first length of moulding.
- Rotate saw to 45 degrees to the right and cut the second mating moulding piece.
- For an inside corner joint, square-cut the first piece of moulding and butt it tight into corner.
- Mitre-cut the second piece to 45 degrees.
- Highlight the leading edge of the moulding with a pencil.
- Cut along leading edge with a coping saw.
- Smooth the cut edge with 100-grit sandpaper to create a tight joint.
Crown moulding refers to a large family of mouldings which are designed to gracefully flare out to a finished top edge. Crown moulding is generally used for capping walls, pilasters, and cabinets, and is used extensively in the creation of interior and exterior cornice assemblies and door and window hoods.
You’d love to read: Best Computer Desk For Home Office
In recent times, crown molding have generally made their appearance as mostly decorated plaster or wooden trim where walls meet ceilings.